主要Δ：偏軸輪必須要拖動到最多點切角刀才會動。

  挑選好切角刀，用力扳彎矩輪輪(圖(2)中3)，改變好切角刀的與圓邊銅墊的地方，將被切物放至事情舞臺上，與兩小側板靠齊，尖角與裁刀“R”中對正，然而扳出手柄或跳板，當彎矩輪輪準備運功后，再按下手柄或跳板。這個時候切角刀順利完成兩個剪裁循壞后停于較高點。

  如踩住踏板車車、或搬手柄不用時，切刀也會連續式裁剪。用手掌扳動偏心輪輪輪設定切角刀下上旅程時，應將切刀扳變回最高的點，使連桿(圖(2)中2)鉛垂于上班臺位置上。一旦違反，當扳著手柄(圖(2)中14)或踩下踏板車車(圖(2)中19)時偏心輪輪輪(圖(2)中3)將也不會甩動即切角刀不允許下切。

  Note Δ: The eccentric wheel must be rotated to the highest point before the cutter moves.

  Select the cutting knife, use the hand to pull the center wheel(Figure 3), adjust the position of the cutting knife and the round corner copper pad, place the cut object on the work table, and align with the two small side panels. The sharp corner faces the center of the cutter "R" and then pulls the handle or pedal. When the eccentric wheel starts to move, the handle or pedal is released. At this time, the cutter completes a cutting cycle and stops at the highest point.

  If you step on the pedal, or when the wrench handle is not put, the cutter will cut continuously. When the eccentric wheel is used to adjust the angle cutter's up and down stroke, the cutter shall be pulled back to the highest point so that the connecting rod(2 in Figure(2)) is perpendicular to the table position. Otherwise, the eccentric wheel(3 in Figure(2)) will not rotate when the handle is pulled(14 in Figure(2)) or the pedal is stepped down(19 in Figure(2)), that is, the cutter can not cut down.